The editor
Keyboard shortcuts
A key picks a tool, and the toolbar shows the one picked. ⌘ is Ctrl on Windows and Linux.
Everywhere
| ⌘Z | Undo |
| ⇧⌘Zor⌘Y | Redo |
| DelorBackspace | Delete the selection. On the PCB a part stays: delete it in the schematic or the Inspector |
| Esc | Cancel, or stop following someone |
| Space-dragormiddle-dragortwo-finger scroll | Pan |
| Wheelorpinchor⌘-scroll | Zoom |
| ⌘G | Group the selection (as a block, on the schematic) |
| ⇧⌘G | Ungroup |
| [ | Show or hide the parts library |
| ] | Show or hide the side panel |
| ⌘L | Open or close Sakura, from anywhere |
| ⌘B | The menu of every sheet, once there are two |
Schematic
| V | Select |
| W | Wire |
| L | Net label |
| B | Block |
| U | Bus |
| / | Bus entry |
| P | Line |
| ⇧R | Rectangle |
| ⇧T | Text |
| R | Rotate |
| X | Mirror top to bottom |
| Y | Mirror left to right |
| ⌘A | Select all |
| ⌘Cor⌘V | Copy, paste |
| ⌘D | Duplicate |
| T | Tidy the sheet, or the selected block |
| F | Fit |
| ⌥↑ | Up to the sheet above |
While drawing a wire:
| /orSpace | Flip the bend |
| Backspace | Undo the last corner |
| Esc | Done |
PCB
| S | Select |
| X | Route |
| V | Via (from any other tool, back to Select) |
| L | Next copper layer (⇧L the one before) |
| R | Rotate |
| F | Flip the selected parts to the other side; with nothing selected, fit the board |
| Z | Copper zone |
| K | Keepout |
| O | Slot |
| M | Dimension |
| T | Text |
| D | Line |
| A | Arc |
| C | Circle |
| B | Rectangle |
| P | Polygon |
While routing a trace:
| V | Place a via and carry on on the next layer |
| W | Next preferred trace width |
| A | Arc |
| / | Flip the bend |
| Backspace | Undo the last corner |
| Esc | Done |